Study of the anisotropy of the polycrystal properties based on texture data

The results of studying correlation between the crystallographic texture of polycrystalline materials and anisotropy of their physical and mechanical properties are considered. The methods for calculating the anisotropic properties of polycrystals based on the data obtained by X-ray methods of direct and inverse pole figures are reviewed. Calculation methods based on the use of the distribution function of crystallite orientations require the use of a large amount of experimental data and, hence, they are not suitable for express estimation of the anisotropy level of the physical properties of samples upon their thermomechanical processing. A method for rapid estimation of the anisotropic properties of the sample based on the use of Д; ("orientation factors") in the calculations, is proposed. Experimental data of X-ray analysis (method of inverse pole figures) are used to calculate the absolute and relative deviations of the physical parameter of textured polycrystal from the same value in the isotropic sample. The contributions of individual crystallographic orientations to the formation of the anisotropy of the properties of the sample are estimated. The dynamics of quantitative changes in the anisotropic properties of a polycrystal in the process of texture formation is studied. To analyze the source of the most rapid changes in the anisotropy of properties, we used the coefficients of the "response" matrix, the calculation of which does not depend on the results of specific diffractometric measurements, but is common for all metals with a hexagonal close-packed (hep) lattice. The anisotropy of the coefficient of thermal conductivity, electrical conductivity, and thermal diffusivity was calculated for the samples of deformed yttrium which underwent cold rolling with a reduction ratio of e = 25%. It is shown that the final physical properties_of the hep polycrystal are largely determined by the pyramidal crystallographic orientations {1015}, {1124}. The results of the study form a basis for analysis of the anisotropy of the physical properties of hep-metal samples upon thermomechanical processing.

polycrystal, texture, anisotropy, structure, deformation, rare-earth metals, X-ray analysis, diffraction.

1. Kocks Е, Tome С., Wenk H.-R. Texture and Anisotropy. Preferred Orientations in Polycrystals and Their Effect on Material Properties. — Cambridge University Press. 2000. — 676 p.

2. Hielscher R., Mainprice D., Schaeben H. Material Behavior: Texture and Anisotropy. In: Freeden W, Nashed M., Sonar T. (eds). Handbook of Geomathematics. — Berlin: Springer, 2010. P 973 - 1003. DOI: 10.1007/978-3-642-01546-5_33.

3. Adamesku R. A., Gel'd P. V, Mityushov E. A. Anisotropy of the physical properties of metals. — Moscow: Metallurgiya, 1985. — 136 p. [in Russian].

4. Wenk H.-R., Van Houtte P. Texture and anisotropy / Rep. Prog. Phys. 2004. Vol.67. N8. P 1367. DOI: 10.1088/00344885/67/8/R02.

5. Mikheev V. A., Zaitsev V. M. Anisotropic materials. — Samara: Samar. gos. aerokosm. univ, 2012. — 79 p. [in Russian].

6. Zolotorevsky N. Yu., Rybin V V Fragmentation and texturization during deformation of metallic materials. — SPb.: Izd-vo Politekh. univ, 2014. — 208 p. [in Russian].

7. Betsofen S. Ya., Il'in A. A., Skvortsova S. V, Filatov A. A., Dzunovich D. A. Patterns of formation of texture and anisotropy of mechanical properties in sheets of titanium alloys / Metally 2005. N 2. P 54 - 62 [in Russian].

8. Ohta K., Nishihara Yu., Sato Yu., Hirose K., Yagi Т., Kawaguchi S., Hirao N., Ohishi Ya. An Experimental Examination of Thermal Conductivity Anisotropy in hep Iron / Frontiers in Earth Science. 2018. Vol. 6. N 176. P 1 - 15. DOI: 10.3389/ feart.2018.00176.

9. Luzin V, Gnaupel-Herold Т., Prask H. Evaluation of local and global elastic properties of textured polycrystals by means of FEM / Material science forum. 2002. P 407 - 412.

10. Borodkina M. M, Spektor E. N. X-ray analysis of the texture of metals and alloys. — Moscow: Metallurgiya, 1981. — 272 p. [in Russian].

11. Kolbasnikov N. G. Physical bases of plastic processing of metals. — St. Petersburg: Izd. SPbGPU, 2004. — 268 p. [in Russian] .

12. Ivanov A. N. Crystallography, X-ray and electron microscopy. — Moscow: MISIS, 2009. — 22 p. [in Russian].

13. Farber V. M., Arhangel'skaya A. A. Diffraction analysis methods. — Yekaterinburg: UGTU-UPI, 2005. — 113 p. [in Russian].

14. Ivanova T. M., Savyolova T. I., Sypchenko M. V The Modified Component Method for Calculation of Orientation Distribution Function from Pole Figures / Inverse Problems in Science and Engineering. 2010. Vol. 18. P 163 - 171.

15. Paromov V V The study of the texture of metal sheets by the method of direct pole figures. — St. Petersburg: SPb gos. polytekh. univ, Inst, metallurgii, mashinostroeniya i transport^ 2013. — 35 p. DOT 10.18720/SPBPU/2/idl7-8.

16. Serebryany V N., Kurtasov S. E, Litvinovich M. A. Studying ODF-errors when reversing pole figures using the statistical method of ridge estimates / Zavod. Lab. Diagn. Mater. 2007. Vol. 73. N 4. P 29 - 35 [in Russian].

17. Ivankina Т., Mattis Z. On the development of quantitative texture analysis and its application in solving problems of earth science / Fiz. Element. Chast. Atom. Yadra. 2015. Vol. 46. N 3. P 665 - 758 [in Russian].

18. Mityushov E. A., Odintsova N. Yu., Berestova S. A. Formal scheme for calculating the effective elastic properties of textured metals / Matem. Modelir. Sist. Prots. 2003. N 11. P 76-80 [in Russian].

19. Grechnikov F. V, Erisov Ya. A. Development of plasticity criterion for the calculation of forming highly textured anisotropic blanks / Vestn. Samar. Gos. Aehrokosm. Univ. 2012. N 1(32). P94-99 [in Russian].

20. Trusov P. V., Shveikin A. I. Multi-level physical models of single and polycrystals. Statistical models / Fiz. Mezomekh. 2011. Vol. 14(4). P 17 - 28 [in Russian].

21. Gorelik S. S., Skakov Yu. A., Rastorguev L. N. X-ray and electron-optical analysis. — Moscow: MISIS, 2002. — 306 p. [in Russian].

22. Adamesku R. A., Grebenkin S. V, Stepanenko A. V Texture and Deformation Mechanism in Yttrium / Physics of Metals and Metallography. 1992. Vol. 74. N 5. P 535 - 537.

23. Stepanenko A. V. Texture formation during the precipitation and recrystallization annealing of gadolinium / Usp. Sovr. Nauki Obrazov. 2016. Vol. 3. N 6. P 85 - 88 [in Russian].

24. Zinov'ev V E. Thermophysical properties of metals at high temperatures. — Moscow: Metallurgiya. 1989. — 384 p. [in Russian].